XIEGU X6100 No transmit power on FT8, both with WSJTX and JTDX
I received my X6100 last week and was impressed with the build quality.
I successfully made contacts on SSB and CW. I configured JTDX and WSJTX and was able to recieve without issue with both but most of the time was not able to transmit, oddly enough sometime it worked, which made no sense. This setup was using my laptop with windows 11 and a USB-C to USB-C connection to the radio. Most of the time no matter what I did it would key to transmit but no output power. After watching quite a few youtube videos on how to configure it, nothing seemed to work. After many hours of troubleshooting, on a wilm, I used WSJTX in tune mode to key the radio which showed 0 power, then had windows sent a test pattern through the usb port instead of speaker and low and behold i got transmit power (on a dummy load of coarse).
To further the test, I configured my raspberry PI with WSJTX and connected using the same cabling to the radio and it works first time and every time since.
This leads me to believe that the WSJTX and JTDX software does not reliably send audio thru the windows USB-C audio port. My dell only has USB-C. I have tried both the windows standard drivers and the Xiegu cable driver from the radioddity.com site. Since windows sounds go through the port just fine, I am beginning to believe it is not a windows issue.
I have seen a few others on the group having the same transmit issue and am wondering if my test can be duplicated elsewhere.