XIEGU X6100 battery consumption in rx mode

XIEGU X6100 battery consumption in rx mode 
XIEGU X6100 running time on built in battery in rx mode

Hi i am doing my 4 charge/discharges , and on my last one now, The radio has been left to discharge just in rx mode on low volume,
and after a full charge the radio shuts down only after 3.5hrs, This does not seem correct as the manual says the radio only takes 330ma max in rx mode,
how long are users getting with there radio in rx mode on the internal battery,


XIEGU X6100 battery consumption in rx mode

Hi 3.5 – 4 hours is about right. If on low brightness and low audio then I have had just over 4 hours. I doubt the 330 mA figure used from the internal battery at around 7.5V . It has an internal Regulator for the internal power and this when fed form an external 12.5v. the RX is using around 400mA of this supply but will go up when on the lower voltage internal supply.

We will not know the true value for current draw on RX off internal supply or battery capacity until the unit is opened up I guess 2500mA battery capacity and 650mA.


There is videos of the x6100 being opened up and the radio does have 2 3000ma battery's fitted but like you say is the capacity 3amp, being Chinese, and yes we need to test what the radio takes without the internal battery connected to the radio,
What run time are you getting on Rx


I have noticed when charging my X6100 battery the current draw is about 750ma. Then when LED stops blinking indicating the battery is charged the display will read about 7.9V. I continue to charge for about an hour and display then shows 8.1V and I think this is when battery is fully charged. I have noticed about this point the rig is draw starts to reduce down to 350ma.


No comments:

Post a Comment

Xiegu X6100 HF/50MHz Portable SDR Transceiver

XIEGU X6100 Users
https://groups.io/g/x6100